Challenge setting up remote access to computers using a DrayTek Vigor Router

Hi Everyone,

I have a bit of experience with setting up Netgear Routers, in particular setting up remote access to a group of client computers (connected to a Netgear Router) using TightVNC: VNC-Compatible Free Remote Control / Remote Desktop Software.

I am currently attempting to setup a Vigor2760 - DrayTek Corp router for remote access, but am having considerable difficulty.

As best I can tell it is a three phase process with this router -

1). Setup a Service "Object" describing the custom VNC service, e.g.:

Object Settings > Service Type...



2). Setup an Address "Object" -



The above dialog only offers "Range", "Sub-Net" and "MAC" as options, and I have tried both the "Range" and "MAC" address options (however neither has been successful).

3). Setup a Filter Rule -



Now when I attempt to connect to the remote computer using TightVNC I see the following error screen -



As a side note I have also turned off the Windows Firewall on the client computer (which I am attempting to connect to).

If anybody can offer any help here it will be greatly appreciated.

Kind Regards,

Davo