"Change adapter settings" is not showing anything

CMD Results:

Microsoft Windows [Version 6.1.7601]
Copyright (c) 2009 Microsoft Corporation. All rights reserved.
C:\Users\J & H>netsh winsock reset catalog
Sucessfully reset the Winsock Catalog.
You must restart the computer in order to complete the reset.

C:\Users\J & H>netsh int ipv4 reset reset.log
Reseting Interface, OK!
Restart the computer to complete this action.

C:\Users\J & H>netsh int ipv6 reset reset.log
Reseting Interface, OK!
Restart the computer to complete this action.

C:\Users\J & H>


I did the reboot after entering all three commands, I then checked the "Change Adapter Settings" page and its the same, blank. Not sure if I was confusing in my OP but I am able to connect to and browse the internet using the PC I am having this issue with.