I just hooked up a Netgear R6300v2 Router. Fairly large house with full basement.
Range pretty good throughout, but I'd like to use the RE1000 for coverage in the far upstairs corner. I also have a Cisco E4200 router that I'd like to configure as an extender. The Netgear Genie doesn't recognize either when plugged in. I assume this is possible, but not sure how to do so. Netgear Tech Support was less than helpful.
Tech Support Guy System Info Utility version 1.0.0.2
OS Version: Microsoft Windows 7 Home Premium, Service Pack 1, 64 bit
Processor: Intel(R) Pentium(R) CPU P6200 @ 2.13GHz, Intel64 Family 6 Model 37 Stepping 5
Processor Count: 2
RAM: 7860 Mb
Graphics Card: Intel(R) HD Graphics, -293 Mb
Hard Drives: C: Total - 462338 MB, Free - 276695 MB;
Motherboard: Acer,
Antivirus: avast! Antivirus, Updated and Enabled
Range pretty good throughout, but I'd like to use the RE1000 for coverage in the far upstairs corner. I also have a Cisco E4200 router that I'd like to configure as an extender. The Netgear Genie doesn't recognize either when plugged in. I assume this is possible, but not sure how to do so. Netgear Tech Support was less than helpful.
Tech Support Guy System Info Utility version 1.0.0.2
OS Version: Microsoft Windows 7 Home Premium, Service Pack 1, 64 bit
Processor: Intel(R) Pentium(R) CPU P6200 @ 2.13GHz, Intel64 Family 6 Model 37 Stepping 5
Processor Count: 2
RAM: 7860 Mb
Graphics Card: Intel(R) HD Graphics, -293 Mb
Hard Drives: C: Total - 462338 MB, Free - 276695 MB;
Motherboard: Acer,
Antivirus: avast! Antivirus, Updated and Enabled
