Cannot modify the trunk port to access port?

Cannot modify the trunk port to access port on Huawei S2700
The trunk port of the original Huawei S2700 switch settings are as follows:
Interface Ethernet0/0/24
Port link-type trunk
Port trunk allow-pass VLAN 1 to 4094
Ntdp enable
NDP enable
Now want to modify the trunk ports to access ports, then use the undo command, but always prompts an error.
[S2700]int Ethernet0/0/24
[S2700-Ethernet0/0/24]undo port link-type trunk
Error: Too many parameters found position.
[S2700-Ethernet0/0/24]undo port link-type
Error: Please renew the default configurations.
[S2700-Ethernet0/0/24]undo port link-type trunk
Finally, consider the default VLAN1, and find the solution for this problem.
[S2700-Ethernet0/0/24]port trunk allow-pass VLAN 1
[S2700-Ethernet0/0/24]undo port link
[S2700-Ethernet0/0/24]undo port link-type trunk

Error:Too many parameters found at '^' position. / / is still not successful,
Which steps I make the mistake? please help?